I have 3 1000 kva single phase transformers and I wish to replace them with one three phase transformer. What is he kva rating of the new three phase, is it 1000 kva also or 3000 kva.
- 5 Answers
- 7006 Views
- Central Moloney, I also Faced
- E-Mail Answers
Answer Posted / h s sandhu
1000 KVa 3 Phase system
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
What is stepper motor?
what is meant by 3rd hormonics ?
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
Leakage current,un balance current which relay using for high voltage transmission?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
What is the difference between the impedance percent and impedance voltage ?
What is CVT and what is relation with wave trap?
Explain how you decide what size of electrical wire do you need?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
