For 7.5kw star delta starter how to calculate
1. Mccb rating
2. Contactor rating
3. Over load relay rating
Answer Posted / joeredd
You need to know the full load motor current at the supply voltage you are going to be using. Your contactors/overload are rated on current. Their voltage rating needs to be higher than the supply voltage. (I.e. 415vac supply, 600vac rating). Knowing the motor wattage (7.5Kw) on its own is not helpful.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is a synchronizing lamp ?
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
what are the difference between PLC and embedded
What will be in Mahagenco Trade Test Exam? I want to know the same.
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
how slip power recovery system work
What is referred to the electron in the outer orbit?
The size and construction of bushings in a transformer depend upon?
How can we choose the rating of submersible motors
where we use the SFU & FSU?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
What is shunt voltage and u v voltage witch one best