hi i'm an Instrumentation student,i have one doubt that we
can call-
> computer science as CS
> Information science as IS
> Electronics & communication as E & C
In the same way what is short term for Instrumentation....?
- 11 Answers
- 10155 Views
- I also Faced
- E-Mail Answers
Answer Posted / md abdullah
short form of Instrumentation=Inst
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
selection of the zener barrier for the hazardeous area zone 0
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
how to calibrate and troubleshooting of leveltroll?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
what are the values of fuel flow rate in various places in boiler.
Explain pH, Conductivity.
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
What is solenoid valve? Where it is used?
what is easiest way to read STL language in PLC?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
why we take %i0.0 as input for twido plc
Explain the working of an electronic level troll.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is IEC code in cables & how to selecting cables?
