Multimeter show phase to neutral volt 230 the per phase but phase to phase 415 not show 460 why.
- 1 Answers
- 5107 Views
- Intas, I also Faced
- E-Mail Answers
Answer Posted / mn krishnamurthy
Line volgae is Root 3 of phase voltage
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
Why the symbol of register is "zig zag"
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
How will polarity test of Dy5 Transformer ?
Why we cant store an ac power. If we coo store in which device we can?
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
bus bar design conditions and sizing pls tell me quickly
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
How to calculate per unit impedance of transformer?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
Which types of gate insttaled in static switch. Please give me answer.
