what is use of stater and choke in tube light.?
- 2 Answers
- 4737 Views
- Aditya Birla, I also Faced
- E-Mail Answers
Answer Posted / vilas
Choke is used for to reduce the low frequency signals that means it bloks that signal
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
what are inherent currents?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
wow to calculate the transformer rating(KVA)
The size and construction of bushings in a transformer depend upon?
Why the field rheostat is adjusted such that the voltmeter reads 380V
what is plunger and what's the use of it in motor alignment?
How to calculate energy stored in a capacitance
What is difference between isolator and circuit breaker?
What is MSL designation of a motor and same may be provided in details.
Difference between ac parallel circuit and ac series circuit?
What is critical disruptive voltage?
What is the unit of charge and current?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
