Interested to Buy Any Domain ? << Click Here >> for more details...
what is resonance in electrical circuit and its effect?
where we get high resonance and low resonance?
- 1 Answers
- 3298 Views
- I also Faced
- E-Mail Answers
Answer Posted / nur.asidik
resonance mean when XC is equal to XL,
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to find out 3 phase complex power in per unit in unbalanced system?
how we calculate electrical load on a building according to area?
difference between the applicability of nortons and thevenin theorem
What types of high speed CMOS circuits have you designed?
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
What is servo motor and what are the applications of servo motor?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
which protection used in power plant?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
Is it possible to connect a safety device in to parallel?
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
