A 3 phase motor, 440 voltage, induction motor. If we take
out rotor from motor and if we give supply 440 volt to
stator then what happens?????
- 20 Answers
- 18532 Views
- I also Faced
- E-Mail Answers
Answer Posted / nur.asidik
in practice, stator will heat up because of losses,
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How is the gain affected by the introduction of feedback in a control system.
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
How to measure the earth resistance value in a concrete pavement(flood light area)?
Type of motor stater detail and working detail
Why neutral cable carry current.
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
How to connect the chemical earthing and complete process tell me plz
help me with the question that might be ask on the interview for technical position
A d.c. Shunt motor is found suitable to drive fans because they require?
if a.c supply is given to the motor,, what happen?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
What is the tube exial fan?
What are differences between Voltage, EMF & Potential difference ?
