Answer Posted / mian kamran ali
cavitation is occured in pump due to formation of bubbles in the roter which causes damage and us pleasant sound from the pump...
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is offset in a control system.
What is difference between radial vibration and axial vibration explain in detail .
How to convert Differential pressure to flow in TPH
what are the use of belew gear in general ??
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
what is the usage of QDV & VOLUME BOOSTER
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
key phaser where is use and work
can you send remote seal interface level transmitter calculation steps for oil water saperator.
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
use of split range ? where it is used ? in which control loop it is used ?
why fuse block is not used for AI signal?
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
What is the diffrence between ff tx and non ff tx
