GIVE THE TEMPERATURE RANGE OF PLATIUM RESISTANCE THERMOMETER.
- 7 Answers
- 6741 Views
- DVC, I also Faced
- E-Mail Answers
Answer Posted / s.mohanty
-200 to 850 deg
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which type of pressure can be measured by primary elements?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
What is three element drum level control system why its better than single element?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
How to Calibrate Vortex Flow transmitter in field
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
What is limitation of the ht.of the displacer of a level trol?
What is shielding effect?
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
