07. 4 main points about check list for rebar works are–
––
- 1 Answers
- 3356 Views
- I also Faced
- E-Mail Answers
Answer Posted / rv
1-Check the number,length,spacing,location and dia of the bar
2-check the development length(ie 50D)
3-Check whether proper clear cover is there at side,bottom and top.
4.Check the alignment (verticality/horizontality) of steel
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is gravity flow?
Find out Cutting Length of Steel for Right angle Triangle? Where Opposite Side 4m, Adjacent side 6m. (Assume cover 40mm)
i want texture painting pwd data
how to caliculate required amount of cement and sand required for 1cu.m.
how to calculate quantity of cement,sand & aggregate for u.c.r / r.r masonry in cm 1:6
What are the important hardware systems used for cad?
A Cat excavator loader of 3Lm*3 heaped capacity bucket is to be used to load blasted rock directly into a crusher of capacity (consumption) of 100L
What is the value of live load that should be incorporated in design of locker room and cash vault room while designing a building for commercial bank?
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
how to identify the failure of building by expansive soils
What is the name of this multiplication factors ?
How much cement and water required for cement selery????
In few lines, please be elaborative on extras and talents that make you a potential candidate for the post:
for 32 dia (EQR HYSD steel) bar how much deduction for 45 and 90 degree band
Define unit atmospheric pressure? Difference between gauge pressure, absolute pressure?
