why we use 4-20 mA to do calibration of the instruments.why
we cant use 0-20 mA?
Answer Posted / kenechi
Yes
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is first echo & echo window in radar type level transmitter?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
how many types of preheaters are in cement industry & what r they can any body explain?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Calibration procedure for electro magnetic flow meter
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
what is function of switch, and how is it work, explain with difination
How is PH sensor works ?
how to calibrate steam control valve in steam turbine
wich is coming the first HAZOP OR SIL
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com