Answer Posted / mohamed rafik
The opening or closing of control valves is usually done automatically by electrical, hydraulic or pneumatic actuators. Positioners are used to control the opening or closing of the actuator based on electric, or pneumatic signals.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
in differential pressure transmitter,min&max pressure range for hp&lp
List three types Level Switches with their working principles
hi! i want to know about mpse exam.
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
What is hp & mp seperator .& what is its working principle ?
Differentiate between ultrasonic flowmeter and radar type flow meter
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Specific gravity.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
why we are using drum level control valve air to close?
How to Calibrate Interface Level Troll in field
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What are de-saturators?
How does temperature bath work? How does coil gets heated only by applying some current?
