Can be operate control valve without positioning if yes ?
how and why?
Answer Posted / ravi
Without positioner control valve will become on off valve because position feedback dose not transist.
If control valves are able to operate within 3 - 15 psi, that case can possible though I/p converter .
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calibrate load cell
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Gas equation
what is the usage of QDV & VOLUME BOOSTER
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
How hart protocol can be connected with control valves?
Give 2 application of quartz crystal used for process parameter measurement.
what deference between panel earth and systemearth
Why MUX JB's are using only Temperature Element in Fundation field bus?
all types instrumentation questions want
How to calibrate capillary type level transmitter
What is Erosion in a control valve?
What is 3 element control system
what is span value and zero ? and how set ?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?