why high current produce in case of transformer when turns are
internally gets shorted.
- 3 Answers
- 4923 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / purushotham polyreddy
when high currents produced temperature of the windings has
been increased when the temperature over the steady state
state temperature the insulation of the winding is melt
finally insulation will break so the windings are shorted
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
how to meas-our losses for L.T & H.T
what is the pre charge circuit,what will be work which function it will be use plz tell me
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
what is W.T?specify the acceptable range?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
What is mean by hot and cold loop testing?
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
Differentiate between Zero and Negative sequence current
what is the principle of operation of tungstun bulb ??
What is meant by short-pitched winding?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
How many methods use the load flow solution?
