what happens when we apply dc to a transformer
- 7 Answers
- 9161 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / sasi karthick a
Inductive reactance is zero since F=0; high current pass
thru', windings may damage/burn. And ofcource no mutual
induction.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
what is ground fault in ACB?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
what is the difference between general inverter and solor inverter clerly explain plz
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
how to discharge 3 phase power factor correction capacitors
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
How does cost of generation from hydropower plant compare with other sources of electricity?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
