what is the need of capacitor in transmission lines?and how it works.
- 2 Answers
- 4087 Views
- SCCL, I also Faced
- E-Mail Answers
Answer Posted / michline
In a transmission line,the capacitor is used to compensate the reactive power.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
R=*ΒΆ l/a
How can we calculate the KVA rating of a Distribution transformer from its core details?
What are high pass filter and low pass filter? and What are the flowmeter ?
how is find out kwh step by step
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What is shutdown of electrical sub station?
what type of earthing do for dry fissure rock?
Which type of motor is used in trains, what is the rating of supply used explain working principal?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
describe the Operation of induction generators from bus bars
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
What is safety of Ht panel
How to do stting of vl250 siemens MCCB
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
