Answer Posted / sushant kumar
The technology is using the instrument that measure & control the physical
and chemical properties of material is called instrumentation.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is intrinscily safe system and where we use?
What is the basic difference between Modbus and CAN Open Protocols
What is profibus?
which type inter lock use in petrochemical refinery,and oil & gas?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
Tr. Wiring for calibration.
Full form of KKS when use DCS.
Why boiler chimney area oxyden sensor fixing?
full process of gas turbin?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
