Possible cause of IOP alarm in a DP transmitter:
a: IOP-minimum
b: IOP-Maximum
Answer Posted / dass
IOP is an alarm condition where in the input data has become a bad value as a result of disconnection of a detection terminal or process I/O device or the abnormalities of input destination data .
Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
key phaser where is use and work
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
How r the calculation of process line mpm.
what is the importance of CV in the control valves? how it is calculated?
How digital input and digital output 's are working in dcs
Explain the mechanism behind the turbine meter.
What is ultrasonic flowmeter?
How is PH sensor works ?
Explain working principle of lvdt?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
Why boiler chimney area oxyden sensor fixing?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
what is IEC code in cables & how to selecting cables?