1.how to calculate energy units in our home at singe phase,
2.415V,63A wiring what will use thickness of wire
Answer Posted / m.radhakrishnan
Energy=power *Time
Power=V*I*POWER FACTOR
how many hours consume that power, Example: 60 watts lamp
consume power in 20 hours. Energy=60*20=1200 watts hour=1.2
kilo watt hour=1.2 unit
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
what is the ms flat constant for calculating earth mat design calculation?
R=*ΒΆ l/a
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
Why have to use copper cable for local isolator to motor ?
Why 9KV surge arrester having 7.65KV of MCOV?
which type of motor is used in automatic swing gate
how withstand of hi-pot test outputs of transformer wire 2.5mm
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What happen in ups if phase reverse?
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
An automatic water heater is an example of which type of control system?
EXPLAIN THE ESSENTIAL FACTORS WHICH INFLUENCES THE CHOICE OF SITE FOR A HYDRO ELECTRIC POWER PLANT
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?