What is BMS (Building Managment System)& is AHU / HVAC are
in BMS.
- 12 Answers
- 72583 Views
- Alghanim, I also Faced
- E-Mail Answers
Answer Posted / r.b.singh
BMS was mainly for less the manpower and save the time.The
router in bms was attached with PC and all the controllers
in all the AHU room's.If the control given from bms room
by PC means the AHU was switched ON.And we control the ahu
cooling system via BMS.BMS mnz Bulding Management
System.Via BMS we check the floor temp by the help of
sensor and check the ups readings,dg readings etc......
by the help of controllers in DDC Panel.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
How to calculate P,I&D value in PID controller ?
Make Heater Process Logic.
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
what is sliding spool valves?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
In turbine what does term CDP, NH, HSSOC means.
how to calibrate 0- 150 psi presure gauge by dead weght tester
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
What is the use of double seated valve?
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
2. What is ultrasonic flowmeter?
