Interested to Buy Any Domain ? << Click Here >> for more details...
what is the power ratio between power in star and delta circuit?
- 3 Answers
- 5323 Views
- I also Faced
- E-Mail Answers
Answer Posted / sandeep
it's 1:1
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is Negative Potential Bias
What is meant by bus bar protection?
what the function breaker failure scheme, how is it operated
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
what is the best method of grounding in 30 MW generator?
What is the voltage gain or transfer function of amplifier?
What is I to C?
How can we calculate cable size in Low voltage & high voltage
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
How would you calculate power loss in a resistor?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
