What is the diffrence between PL Lamps and CFL Lamps
- 5 Answers
- 79716 Views
- I also Faced
- E-Mail Answers
Answer Posted / ram dargad
PL (stands for Philips Lighting) lamps are older version of CFL (Compact Fluorescent Lamps)lamps which use external ballast. Current versions use built in ballast, thereby making it easier to install, maintain & replace.
| Is This Answer Correct ? | 11 Yes | 27 No |
Post New Answer View All Answers
What must be the minimum distance maintained between 2 Generators as per International standards?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
transformer phasor diagram under load explain it?
What do you mean by passive circuit elements and why these are called passive?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to test YNyn0 vector group in transformer?
what is the use of power transformer in GSS.
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
What is voltage divider rule?
What are the disadvantages of hydropower?
why dimmerstate always connected in star connection? what will happen if it connected in delta?
explain PV modules in solar energy generation.
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
