Answer Posted / saahil kumar
DC is used for starting the Diesel Engine, which is used as a prime mover for the generator.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
what will be project cost for 100 kv transformer connection under oyt scheme.
how to decide the capacity of accl
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
how many joints are allowed in underground HT cable of 1 KM
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
if a.c supply is given to the motor,, what happen?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
What are the types of the glands and difference between single and double compression type of cable Glands.
is ac supply can store
how can i improve the power factor in domestic (230v)
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
Advantage of LT panel vs HT panel