Interested to Buy Any Domain ? << Click Here >> for more details...
what is the advantages of Lighting transformer?.. is it
possible to reduce the power consumption ?.
- 6 Answers
- 31722 Views
- Lucas TVS, I also Faced
- E-Mail Answers
Answer Posted / sanjay kumar
lighting transformer is a transformer witch is required for lighting load near to supply source end to limit the fault current due to very low impedance near the main source. it also reduce the high voltage spikes & EMI in the primary to transfer in the secondary.It also used where the primary supply is 3-phase & 3-wire to get neutral point in secondery.
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
what maximum range of star & delta in hp or kw ?
What is gain margin?
Why you want to join non technical field when you are an engineer?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
Why saturation region slowly shifted in the left side?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
what is 30-phase of transformer
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
Write the force balance equation of ideal spring element.
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
What are test signals and their significance?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
what is the necessity of under ground cables ??
