Answer Posted / 7anoter4
Usually a vertical grounding electrode –made of copper,
copperweld steel, stainless steel or else-and length of 3-20 m
is driven in earth and the upper end will be exposed in a pit
covered by a lid- about 0.3-0.6 m deep and 0.3 m diameter.
This pit facilitates electrode connection with horizontal
grounding conductor and as a check point of electrode state-
grounding [earthing] resistance measurements and other.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is diversity factor in electric installations?
how can we change the phase angle b/w two phase?
Explain the role of a car driver as one of a feedback mechanism.
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
difference between semiconductor & conductor & insulator?
What is the maximum percentage voltage drop (vd%)for a motor control center
how to calculation increase power factor for single phase
what are the disadvantages in GIS over AIS
how to calculate the tarriff for an industry whose kva demand is 10 mva
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
hi friends if you have any 400KV Substation Erection and installations Drgs please send to me.My email id:kandi.suresh441@gmail.com
What is excitation in case of dc motor?
