1)Why Bearing used in Motor and pumps.
2) Why Mechanical seal used in Pumps.
Answer Posted / zeba ansari
1. The basic function of a bearing is to aligned the driving shaft with the driven shaft, so that the shaft does not bend or get damage due to load or pressure.in case of pump & motors , it is used for the same purpose.
2. purpose of seal is to allowed prevent leakage of the flowing fluid
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
On what basis can sliding contact bearings be classified? Explain?
wap to insert an element in array at a particular location
alignment formulae for any two shafts for shim correction
what is Direct control valve ? explain its practical applications?
Explain why re-heater is used in gas turbine
What is the mathed of maintain oxizen level in a air tite A/c room.
3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament
What does a rolling offset look like?
why conservator contains 8% total oil qty in transformer any formula to calculate
What is the Working of Cement bulker truck
Name four important properties of a good refrigerant.
Which pump is more efficient centrifugal pump or reciprocating pump?
How does a super charger work in a car?
What are the purposes of spiral gear in a purifier?
Is it possible to make common ducting for Induced draft boiler with Forced Draft Boiler? Induced Draft Boiler is having Agrowaste type and Forced Draft Boiler is of Oil Firing type.