what is the difference between sill beam,Tie beam and plinth
beam?
- 2 Answers
- 21854 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / basavaraj
Tie beam:- fully compression member
sill beam:- fully compression member
Plinth:- is a part of foundation system used to uniformly distribute the weight of a structure.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Define What is a projection line?
While doing civil foundation of machinery. How will you process for it? & We also fixing plates at top surface of foundation, then what is the procedure?
Explain major differences between routing maintenance and major maintenance.
though u r a civil engineer, y r u interested in tcs???
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
Whats the standard thickness of 20'/30' wide rcc service road and what will be the estimated cost per cubit feet
how much to get of BRC lapping in full yield and half yield ?
explain the rale of the government in the construction industry
Formula of area of crane hook
How is improve my knowledge in construction industries....
why the openings of sieves are square io size?
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
what is concrete canvas?
how to caluclate sienerge qty in construction in ap
