In what voltage EHT works(133/132/33/66kv?
- 3 Answers
- 5158 Views
- Adhunik, I also Faced
- E-Mail Answers
Answer Posted / kbt
KSA country EHT is 380KV SEC Company
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
List some examples of renewable energy?
How to design harmonic filter at the project stage without nowing the harmonics levels
what is meant by rotating magnetic filed
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
difference between the applicability of nortons and thevenin theorem
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
why we testing the core balance of the transformer before comissioning?
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
what is the differance between HT motors And LT MOTORS.
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
why and how voltage sharing in transformer, during magnetic balance test ?
