Interested to Buy Any Domain ? << Click Here >> for more details...
difference between specification and method of statement
- 3 Answers
- 17272 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / devendra
should be mi9nimum20mm between the brick to brick.
| Is This Answer Correct ? | 3 Yes | 13 No |
Post New Answer View All Answers
how much deduction will be in 32 mm dia HYSD steel bar for 45 and 90 degree bend
I want to change job.If You have any vacancy please contact me in this mail id-parthamitra086@gmail.com.Myself partha mitra.Diploma in civil engineer with 4+ yrs. exp.Now in kolkata.If you confirm me then I will send my detail resume to you.Also send your mail id to me.My mail id is-parthamitra086@gmail.com.I will be very much thankful to you.
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
how much shouid be the rate for ready mix concrete per cubic meter
how can calculate the compressive strength of concrete cylinder by water cement ratio ?
how to calculate the strength of rebound hammer test reading in building construction ?
what are the types of design? which type of method is used at what type of design & why?
how many digree of freedom in four bar chain
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
What is binding spacing of the rebars at lapping zones.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
how much quantity of cement,sand and water required for 1 sq feet flooring work .
hai, kindly send anyone for output workers format details for construction project in foundation to finishing.
