HOW TO MEASSURED THE AMPS RATING FOR SUITABLE CABLE SIZE?
- 4 Answers
- 5901 Views
- I also Faced
- E-Mail Answers
Answer Posted / gaurav gupta
for al cable - 1 to 1.5 amp per sq.mm area
for cu cable - 2 to 2.5 amp per sq.mm area
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the high series capacitance winding on high voltage power transformer ?
how are reversing the direction of rotation of dc motor
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
What is Plank's Law?
what is the importance of Partial Dischage test for Electrical Equipments
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
Why we use mho Relay in long transmission line?
what are the available sizes of pin type terminal lugs in the market today?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
ROC converges if poles and zeros lie inside a. Origion b. Z=1
in shunt clippers why a resistor is used in sereis with the input
