Why we use cosine angle for calculating power factor not in
sine angle ?
Answer Posted / sanjana singh
Literally watt power factor means the factor of real use full power that is going to transmit from the total apparent power produced so that is why it is the ratio of real power to complex power which can b taken as cosine of angle ratio from power triangle. It is the reason why power factor is cos theta.
Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Parts of machine and their discription in details with suitable photo
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
how slip power recovery system work
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Is it possible to measure the voltage of a battery from a single terminal?
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
which protection function should measure RMS value of current&DFT value of current?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
whats the differece between Exd and Exe
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
how to calculate IR value of 33KV cable ??
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
Explain marx circuit.
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?