what is the difference between LT & HT Motors
- 11 Answers
- 86681 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / subasis panda
LT RANGE MOTORS – 230 VOLTS, 415 VOLTS
HT RANGE MOTORS – 6600 VOLTS AND 11000 VOLTS.
The insulation level in HT motor
is more strengthener than LT motor. the current is very high
in same rating LT motor so the rating of the protection
device will be higher than HT type motor.
| Is This Answer Correct ? | 13 Yes | 11 No |
Post New Answer View All Answers
why dimmerstate always connected in star connection? what will happen if it connected in delta?
How many size of cable required for a 300m long and 30kw inductive lode
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
How DC earth leakage currents can be reduced ?
If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
Why are the laminations insulated from each other?
What is dynamo function in DG sets and draw block diagram?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is the difference between solid grounding and impedance grounding?
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
