Answer Posted / nani
I agree with Mr. Sheikh. All starters will be used for that purpose only..
What are the relative advantages of using Star Delta Starter compared to other starters?
That is importent.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the formula of starting current of 3phase and 1 phase motor???
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
What is the size of a 60 watt and 80 watt tubelight?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
how much LT load can bear by the 100 KW HT connection.
Why the earth to phase voltage is high 250 compare to other two phases
what will happen if there is a voltage leakage or current leakage in an electrical train
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
How much minimum insulation required between 11kv/3.3kv transformer windings?
How to use earthing on shipments.
Define coil span?
Power Factor Correction Panel (Manual & Automatic)
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
