What is the deffrence between Siemens S7-300 & S7-400 PLC?
- 4 Answers
- 30973 Views
- ADC, I also Faced
- E-Mail Answers
Answer Posted / taj
Siemens rates the S7-300 as a medium level PLC, and the S7-400 as a high-level PLC. So there are differences in work memory, processor speed, number of communication links and I/O connectivity.
First point, the S7-400 family is rack-based (Multi-pin backplane linking all modules, from power supply to I/Os) whereas the S7-300 is a bus-linked platform (a serial connector links all modules). So essentially the physical layout limits the S7-300 back[plane exchanges to MPI speeds (187,5 Bits per second), whereas the S7-400 uses parallel connections over the backplane rack, permitting higher exchange rates, and a higher module-density.
Second point, the form factor of the S7-300 is smaller, more compact than the S7-400, so this is something to take into account if space is a premium (inside a small machine panel, for example).
Now, the higher S7-300 CPUs (especiatlly for the new S7-317 and S7-319)have specs that approach (and sometimes pass) the specs of lower end S7-400 CPUs, so the distinction is starting to blur.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
Wind mill
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
What is the complete procedure of erection of electrical panel in industry
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
What do you understand by oldham's coupling ?
Why to keep capacitor bank off while generator running.
How PSV sizing being done
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
hr round
what are the applications of PLC?
