On drum level, why we are using air to close Control valve?
Answer Posted / sanjay k
It means we used air failed to open condition to avoide
starvation in boiler.
At any condtion water must be kept in boler and in drum.
in case air fail the valve shold open and water goes in
boler.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
Questions on flow meters,few questions on HART protocol,
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What is super thermocoupal?
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
What is instrumentation instrumentation engineering?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
what is temperature compensation?
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
ORP sensor working principle?
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??