why there is a high voltage line in multiplication of 11?i.e.-
-66kv,11,kv,22kv
Answer Posted / arun
VOLTAGE LINE ONLY DEPEND UPON FORM FACTOR, THEN FORM FACTOR RATIO IS =RMS VALUE /AVG VALUE= 1.11. THEN ONLY HIGH VOTAGE LINE IN MULTIPLICTION OF 11 SERIES.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
can we conduct the swineburne's test on a dc series motor? why?
Difference between ac parallel circuit and ac series circuit?
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
What is the differentional relay...what is the work of this in power Tx. how it is works..
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
Meaning of ingrace protection for motor.for ex IPXY
What are the advantages of speed control using thyristor?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
how can i get an electrical c-certificate?
how to increase senstivity of ct
How to checked frequency drive output voltages?