What is an EN Material. What is the difference of EN8, EN24,
EN40.
- 5 Answers
- 82604 Views
- Aeronautical Society of India, Ecil, Finearc, Saint Gobain, Scitech Centre, Universal Engineering Works, I also Faced
- E-Mail Answers
Answer Posted / shyam shendur
EN8 also know as 080M40. An unalloyed medium carbon steel. EN8 is a medium strength steel, good tensile strength. Suitable for shafts, stressed pins, studs, keys etc.
Available as normalised or rolled. EN8 is supplied as round drawn/turned, round hot rolled, hexagon, square, flats and plate
EN24 also known as 817m40 comes treated in the T condition to 850/1000 N/mm2 we can offer EN24T in plate from 10mm thick up to 300mm, diameters from 10mm up to 950mm, squares from 20mm to 300mm and flats 20 x 10 up to 3000 x 300mm from stock. AISI 4340, werkstoff 1.6565.
| Is This Answer Correct ? | 24 Yes | 5 No |
Post New Answer View All Answers
What causes diesel engine trouble when using heavy oil?
please send interview questions on foundry. my email id is m_vijaypanday@yahoo.co.in
how does the lybrinth glands work in sealing a turbine? how exactly turbine sealing is done? principle of it?
Is OHNS steel is equivalent to O1 tool steel? Suppliers give OHNS material for AISI O1 STEEL telling that both are equivalent materials. Is this correct?
Explain the working of 6 stroke engine?
Explain the differences between pneumatics and hydraulics?
An employ has after increment has Gross Salary 22000 rupees per month. Earlier he was covered in ESI . now should we deduct ESI from his salary or not.
Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?
Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards
i am looking for a 4 kw immersion water heater /in the USA is this a 220 system or 240
what type of questions will be there in the written paper of tata motors ?
what happen when there is moisture in the TX valve?rac
What are the causes of positive and negative propeller slip?
i am appearing for the interview of the company SANDVIK??so if u can send me some questions or suggestions on how to prepare,it would be of great help to me.u can send the above at ekjain@yahoo.co.in.thanking you.
i am preparing for vsp management trainee technical 2010.can any one send me modelpapers of preliminary written test.
