We have a Yokogawa Micro-XL DCS, which is having around 300 I/O, but whenever there is any wire gets grounded in field, the 24v supply to all loops gets dipped & all the indications at DCS goes to IOP(shows input open), at present we have fixed 500mA fuses in all the lines but which does not working. Does it required to replace with lower amps fuse, then how much or is there any other solution for this.
- 2 Answers
- 5798 Views
- I also Faced
- E-Mail Answers
Answer Posted / dipankar layek
AT +VE END OF TERMINAL BLOCK USE 100 MA FUSE IN DI CHANNEL AND 50 MA FUSE IN AI/AO CHANNEL.
I THINK THIS WILL SOLVE YOUR PROBLEM.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
if in a level tx height is given, how u calculate the ranges of the tx?
What is solenoid valve? Where it is used?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
In turbine what does term CDP, NH, HSSOC means.
How ejector(or)evactor air pump is working in thermal power plant?
How to calibrate the flow transmitter
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
which type of filter gives the constant phase characteristics?
is motorized valve closed when power shutoff?
What is profibus?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
How to Calibrate Temperature Switch in field
what is 24vdc live and dry supply
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
