Interested to Buy Any Domain ? << Click Here >> for more details...
Why do we choose 33kV transmission for industrial purpose
and 11Kv for township?
- 1 Answers
- 3986 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You get enough space to construct a 33KV substation inside
the factory premises
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is Fan Control Cubicle
can i use 2000/5A Clamp meter to measure HT cable
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
Write the force balance equation of ideal spring element.
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
What are locations arc protection relay is fixed.
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
Define non-touching loop.
What is resonant frequency?
the winding of Generator and Motor is star or in delta ? and why
How the over load setting for HT Motors calculated-provided in Numerical Relay
why zero sequence impedance measurement is not applicable for single phase GT
