primary of transformer connected to Dc supply in series with
switch, and secondary connected on ammeter, what happens
when swith On and OFF. (or) if continuously On and OFF
- 9 Answers
- 6897 Views
- I also Faced
- E-Mail Answers
Answer Posted / jagadeesh
it works ausally when connected to primer y in series with
high resistance
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is sevice settings for mccb?How can be it setted?
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
How to calculate the heat load for a electrical room
What is steady state response?
Pleae send me last 5 years of Question book about RRB chennai.
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
what is harmonics? what are the factors it will depend upon
What is the importance of earthing?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
what is the difference between skin effect
