Capacitor bank require for 1000amp load
Answer Posted / wareagle
The need for capacitors is determined by load power factor
and utility billing rates. If you load has a PF of 1.0,
then no capacitors are needed. If the utility does not bill
for low PF, then you may not need capacitors.
Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
Difference between low impedance and high impedance Restricted Earth Fault
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
what is inter connected dc generator?
why swityard is necessrry requirement in any bis power distributin systems?
Atwhat condition reverse power relay will act?
What are the Full Forms of TVM, MTL, CVT ?
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
redundant connection in contactor?
what are the steps involved in generator load test?
What is meant by reset level of the relay?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
What are the basic & Majour problems in UPS ?
Define what is power quality meter ?