Answer Posted / sjtbehera
clarify your question
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
I am a civil engineering student and going to attend interview in this week in an IT company.Will they ask me questions about my area of interest or cs
why we use for testing of compression strength concrete the size of specimen 150x150x150. why we are not using another dimension like 100x150x100 uneven dimension.
How to calculate canal slope curvature qty!
I have completed building maintenance course in mcvc stream .. can I apply for the post of " sthapstya abhiyantriki sahayyak"?
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
is there any thumb rule for calculating construction cost of the building with pile foundation per sft. area?
Rate analysis of Vitrified tile in cement mortor 1:3
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
WET BULB TEMPERATURE AND DRY BULB TEMPERATURE?
What is the coeffiencent Friction Angle between Steel and Ashphalt?
I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,
Formula of area of crane hook
qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor
what is w/c ratio in dry lean concrete for m10 mix design
What sizes of stones chips are used for foundation, column and floor casting. Please answer in detail.