what will happen if transmitter wire get
shoted?
- 2 Answers
- 7952 Views
- Sabic, I also Faced
- E-Mail Answers
Answer Posted / satorp
For a general installation connected to DCS, reading at DCS
will overanged > 100%. If there is Barrier installed it
will limit energy to field therefore no potential for
ignition spark at SC area.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
why I need valve guard and whats different between guard and positioner ??
detail of mass flow meter pricipal
what is metal of piston ring
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
In turbine what does term CDP, NI, NH, HSSOC means.
why we are using drum level control valve air to close?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
give some question relative instrument fitter?
How to change dcs card in online. (Dsc is maxdna)
