Answer Posted / harikumar
Split range Operation
Reverse acting positioner
Bench set not standard
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
principle of dead weight tester ?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Please can anybody help for control valve sizing step by step procedure?
please send the drdo exam paper
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
Speedtronic system .
what is the difference between scaler and vector drive
How to Calibrate Ultrasonic Level Transmitter in field
Why plc require in analog input 4-20amp & 0-10 volt?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
what is temperature compensation?
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.