Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any possibility of changing in dia of bar from
lower to higher (i.e Lower dia bar at bottom and Higher dia
bar at top)
- 3 Answers
- 6280 Views
- I also Faced
- E-Mail Answers
Answer Posted / lakshmana sekar.s
possible
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Define block?
Used Cement & Sand in 1 Square Meter or 1 Square Feet For Brick Work 0.115mm ? (1:4) (1:6)
how to calculate the density for high density concrete ? or is it same as the density of RC?
weight of 1 cft 10mm, 20mm, 40mm aggregate weight of 1cft course sand
Gidc technical que paper
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
residential buildings,mixing of concrete,structural,construction material,site handling.
How to build the floor to ceiling bookcase?
How do we determine the specific gravity of a cement?
What is the zero value in quantity surveying
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
material required for construction of 1cu.mtr wall (Cement, No of bricks (Brick size 40cm x 20cm x 10cm),sand,Quantity of water
What do you mean by tolerance factor of concrete ?
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
Curing time for 1)R.C.C slab 2)B.W 3)Plastering
