Answer Posted / meka sekhar
MCC (Motor Control Center) is nothing but metal enclosed
floor mounted switchgear to facilitate power to motor
devices. protection. metering & control devices of each
motor circuit will be housed inside panel.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
for 750 kw LT load what will be the ht kva
types of central Air conditioner plant?
What is a surge supressor why its is used in synchronous generators
Draw a block diagramof Three UPS systems connected in Parallel mode?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
WHaT IS THE CONCEPT OF INDUCTION LAMPS IN MODERN LIGHTINGS, and HOW IT WORKS TO EMIT LIGHT ( AS NO ELECTRODES ARE PRESENT ) ?" COULD INDUCTION LAMPS CAUSE INTERFERENCE WITH COMUNICATIONS INTO A STORE USING INDUCTION LIGHTING ? WHAT IS THE BENEFIT OF USING THE LOW FREQENCY INDUCTION LAMP , VERSUS LED , AND VERSUS FLUORESCENT, AND VERSUS ANOTHER KIND OF LIGHTING . THANK yOU MOISES GUINDI
How to choose size of the cable w.r.to current carrying capacity ...
give me applications of sequence bridges . (used in 3 phase un balanced systems)
What is the ratio of Booster transformer?
how to calculate magnetic force genrated by a coil ?
Can any body tell me the different types of LT cables & their application.
What is EHT tariff or Power factor Tariff ????
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
give me atleast four differences between circuit and network