which type your UPS on line,off line give the reason?
Answer Posted / pankaj rathi
In online ups Battery circuits remains allways in line i.e. UPS is connected to load through battery bank. But in ofline ups battery ckt remains as a standby .whenever the supply get cut then ups take the load through battery system.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
explain different types of d.c motors?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
What is Faraday's law
How many types of protection relays are there based on the characteristic?
what is the VA(Volt-amphere)? define with calculation?
What is the earth treantment procedure?
what is kvarh? Please define it With calculation General motors ?
Ac generato how produce power I need for camplet defination
what is POTT and PUTT explain?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?