In footing (mat) if two different dia of rods are to be used
which rod should be placed at top and bottom ( eg. 10mm &
16mm dia rods)
- 7 Answers
- 11953 Views
- I also Faced
- E-Mail Answers
Answer Posted / babu lal nayak
16mm dia bar laid at bottom parallel to short span & 10mm dia bar at top parallel to long span.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
usually hand broken stones are used for cement concrete 1:4:8 in foundation of single /two story houses with a view of economy in construction.what advantages it will give if you use machine crushed stone in place?
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
what is the water cement ratio for plastering
to draw bm diagrams for portal frames under different loadings//
Different sizes of Hollow blocks and its weight. Thanks.
Which brick is best for construction ,either fly ash or AAC BLOCKS
how u design STAGING for Superstructure in BRIDGE construction?
1. HOW MUCH CEMENT AND SAND REQUIRED TO PLASTER 100 SQM WALL. 2. HOW MUCH CEMENT AND SAND REQUIRED FOR SCREED WORK OF AREA 30 SQM
Explain what is the release of lien?
How many axes do cartesian coordinate system has?
What applicable rate of wct in bihar
What is the significance of cost estimate knowledge for an architect?
CAST EFFECTIVE WATER SUMP CONSTRUCTION DETAIL
material used for mendrel use to bend epoxy coated rebar
At one time what is the height of Lift for concreting for Bridge Piers Class B Loading and refer the code.
