On drum level, why we are using air to close Control valve?
- 4 Answers
- 7783 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / swastik d. u
If any problem in your
compressor, sudden stoppage
of air valve get opened. by
this we can maintain drum
level.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is effect of specific gravity in differential level transmitter , explain formula related with this .
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
What is mean by analytical instrumentation?
plz send me general of ongc
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
what is IEC code in cables & how to selecting cables?
How to Calibrate Coriolis Flow transmitter in field
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
what is basic difference between motion balance and force balance in pneumatic instrument?
