Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / suhana singh
OK so what is the criteria where we can decide these
operating conditions or characteristics of load be
considered for using AMF panel (contactor based) or ATS
(automatic transfer switch)
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what are the different kind of cables used for transmissions?
Why 11kv to be generated in generation station
What is the estimated total hydropower potential of india?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
what is the purpose of silicon dropper used in battery charger?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
Explain the operation of grid connected central solar inverter ?
what is the difference between fault current ant short circuit current?
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
why does make gain margin and phase margin on same plot.?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what are the differant std sizes of cable trenches?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
what is the effect of back reactive power on the generator ?
